Lake Charles has absorbed more hurricanes, flooding, and hard freezes in the past few years than almost any city on the Gulf Coast, and every one of those events left more homes needing a real air seal, not just batt insulation stapled back into a reopened wall.
Serving Lake Charles and the surrounding Southwest Louisiana area. Free quotes.
Lake Charles based
We work the Southwest Louisiana corridor
Written quotes
Itemized before any foam goes up
Closed & open cell
The right foam for your climate and budget
Moisture-first
Built for Gulf Coast humidity and storm rebuilds
Lake Charles is still working through a multi-year rebuild after back-to-back Category 4 storms, and the lakefront keeps humidity high year round. Closed-cell foam is the regional standard here because it seals out moisture, adds structural strength, and holds up when storm-driven water gets into a wall cavity.
A lot of that rebuild work sits in and around the Charpentier Historic District, where Victorian and Queen Anne-era homes cannot have their exteriors altered but still need a modern air seal. Open-cell foam sprayed from the attic and crawl space side handles that: it tightens the envelope without touching a single piece of the original siding or trim.
On the commercial side, the corridor around Chennault International Airport and the Port of Lake Charles is full of metal hangars, warehouses, and industrial buildings that take a beating from radiant heat and condensation. Spray foam on the underside of the metal skin stops both, which matters more here than in a typical office park because that airport and port traffic runs every day of the year.
The lake itself, plus Contraband Bayou and the low ground around the I-210 loop, keeps the water table high through most of the city. Homes on piers or slabs near that water need crawl space encapsulation and closed-cell foam that will not wick moisture, not fiberglass batt that soaks it up and holds it against the framing.
Seal the hottest part of your house. Foam the roof deck and stop the attic from baking your living space.
Learn moreThe Gulf Coast standard. Dense, high R-value foam that blocks moisture, adds strength, and resists flood damage.
Learn moreA cost-effective air seal for interior walls and attics where moisture control is less critical.
Learn moreStop ground moisture, mold, and humid air from rising into your floors. A sealed, foam-insulated crawl space.
Learn moreBuild it right the first time. Foam the whole envelope during the build for the tightest, most efficient home.
Learn moreAlready living there? We add spray foam to existing attics, walls, and crawl spaces without a full rebuild.
Learn moreMetal buildings, warehouses, and light-industrial spaces. High-performance foam that cuts energy load and condensation.
Learn moreTell us about your Lake Charles home or project and we'll get back to you, usually within one business day.
Worth checking. Not every repair crew re-insulated with foam when they closed a wall back up, and plenty of Lake Charles homes have a mix of batt and foam from different repair phases. We inspect what is there and quote just the gaps if a full re-foam is not needed.
Yes. Foam goes in from the attic, crawl space, or interior wall cavities during a renovation, none of which touches the exterior siding, trim, or windows that the historic district rules protect.
Yes, that corridor is a regular part of our commercial work. Closed-cell foam on the underside of a metal roof or wall panel stops the condensation and radiant heat that plague uninsulated hangars and warehouses in that industrial stretch.
Crawl space encapsulation paired with closed-cell foam is the standard fix for a high water table. It keeps humid ground air from rising into the floor joists, which is a bigger issue on lakefront and bayou-adjacent lots than almost anywhere else in the service area.
Tell us about the job and we'll come back with a written quote.
